Automated light rail transit is the future!

Author: Wim Platschorre

Placed on: 12 February 2015

Tags: converters, metro systems, traction drive system

Wim Platschorre vierkant_klein

Wim Platschorre

Strukton Rolling Stock

In recent years, we have been working on driverless light rail systems like this at Strukton Rolling Stock. Right now for an entirely new metro vehicle.

You may already know them from international airports: compact, light rail vehicles. They pull up at the platform, the doors open, but the driver is nowhere to be seen. Your eyes aren’t deceiving you, because these systems are indeed fully automated.

In recent years, we have been working on driverless light rail systems like this at Strukton Rolling Stock. We signed a long term agreement in 2014 in which we were asked to develop the traction drive system for an entirely new metro vehicle that will be the new generation of the VAL; a light rail, driverless vehicles for which we have already provided new traction systems for the existing  Toulouse and Chicago fleet.

Detail module


The light rail system will be powered by permanent magnet motors. We are designing the converter, which converts 750V direct current into alternating current for the engines by quickly switching between positive and negative charges according to a specific pattern.

Watch below what Wim has to say about this project and converters:

TnHlkG3kKgM

Wind-cooled

This quick switching between positive and negative is done with the aid of large semiconductors (a kind of transistors) that have been bolted onto a radiator block. This block is cooled by moving air during operation. This is important, because all this switching releases a lot of energy, in the form of heat, while the internals of the semiconductors are  specified for a maximum of 125 °C. Which is already quite hot of course!

With a switching frequency of several thousands of hertz, it’s difficult to design an air-cooled system based solely on the wind passing over the heat sink during movement. We have come up with a cunning solution for significantly reducing the heat released during operation: We have designed a number of  circuits that allow for low-loss switching (soft switching). Microchip manufacturers are currently working on the development of semiconductors made from different materials to limit power losses during switching. But these new semiconductors are not suitable yet for this kind of  operation and performance.

Watch below Wim's detailed guided tour of a converter:

oqAac8KQROI

Stringent safety requirements

Naturally, passengers need to feel just as safe in fully-automated light rail vehicles as in conventional systems with a driver. This means that special attention needs to be paid to safety aspects. This already starts in the design phase: all steps (incl.drawings and calculations) are traceable. Each consecutive stage in the design and production process is accounted for.  These measures are all necessary to comply with IRIS certification requirements. Consequently, the safety standards adopted for the design and production of rolling stock increasingly resemble the requirements that are set for the design of aircraft and spacecraft.

First step towards a prototype

At this point, we have nearly rounded off the theoretical phase involving calculations and simulations. We will deliver a functioning prototype early 2016 and will consequently start the serial deliveries.